Front Lower Control Arm Bushing Replacement Horizontal

Tools Required

1. Remove the lower control arm. Refer to Lower Control Arm Replacement .
2. Secure the lower control arm in a vise.




Important: Use a 1/2 x 20 in standard thread nut with the puller bolt.

3. Assemble the bushing removal tools as indicated:

3.1.	The nut (1)

3.2.	The J 21474-01 washer (2)

3.3.	The J 21474-01 bearing (3)

3.4.	The J 21474-5  (4)

3.5.	The J 21474-01 puller bolt (5)

4. Tighten the puller bolt (5) until the bushing is removed.
5. Disassemble the J 21474-01 and J 21474-5 .

1. Lubricate the bushing with liquid hand soap or equivalent.




Important: Use a 1/2 x 20 in standard thread nut with the puller bolt.

2. Assemble the following bushing installation tools as indicated :

2.1.	The nut (1)

2.2.	The J 21474-01 washer (2)

2.3.	The J 21474-01 bearing (3)

2.4.	The J 21474-5  (4)

2.5.	The J 21474-01 puller bolt (5)

3. Tighten the puller bolt (5) until the bushing is installed into the control arm.
4. Disassemble the J 21474-01 and J 21474-5 .
5. Remove the control arm from the vice.
6. Install the lower control arm. Refer to Lower Control Arm Replacement .

Front Lower Control Arm Bushing Replacement Vertical

Tools Required

1. Remove the lower control arm. Refer to Lower Control Arm Replacement .
2. Secure the lower control arm in a vice.



3. Mark the lower control arm along the flat edge of the bushing flange.




Important: Apply J 23444-A (or equivalent high pressure lubricant ) to the threads of the J 21474-27

4. Assemble the following bushing removal tools as shown:

•	J 21474-27

•	J 21474-13

•

J 34126

•

J 35379

•

J 21474-2

•

J 21474-4

5. Tighten the J 21474-4
6. Disassemble the bushing removal tools.

Tools Required

J 21474-01 Control Arm Bushing Service Set

Important: The lower control arm vertical bushing MUST be installed in the same position which it was removed in order to maintain the original vehicle ride, handling and road feel.

1. Align the flat edge of the bushing flange to the mark in the control arm (1). Ensure that the flat edge of the bushing flange is 30 degrees (2) from the centerline of the lower control arm. Ensure that the thin slot in the bushing is facing outboard.
2. Insert the bushing into the control arm.




Important: Apply J 23444-A (or equivalent high pressure lubricant) to the threads of the J 21474-27 .

3. Assemble the following bushing installation tools as shown:

3.1.	J 21474-27 Puller Bolt

3.2.	J 21474-13 Bushing Installer

3.3.	J 21474-5 Bushing Receiver

3.4.	J 21474-4 Nut

4. Tighten the J 21474-4
5. Disassemble the bushing installation tools.
6. Install the lower control arm. Refer to Lower Control Arm Replacement .