Oil Pump Replacement 3.5L Twin Can V6 LX5

1. Remove the case side cover. Refer to Control Valve Body Cover Replacement .




Notice: Do NOT remove the three bolts which hold the pump together.

2. Remove the oil pump bolts (205-207).



3. Remove the oil pump (200) from the valve body (300).
4. Inspect the oil pump. Refer to the Transmission/Transaxle/Transfer Case Unit Repair Manual.

1. Install the oil pump (200) to valve body (300).




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the oil pump bolts (205-207).

Tighten

•	Tighten the M6 X 1.0 X 20 bolt to 8 N·m (70 lb in).

•	Tighten the M6 X 1.0 X 85 bolt to 12 N·m (106 lb in).

•	Tighten the M6 X 1.0 X 95 bolt to 12 N·m (106 lb in).

3. Install the case side cover. Refer to Control Valve Body Cover Replacement .

Oil Pump Replacement 3800 L36

1. Remove the case side cover. Refer to Control Valve Body Cover Replacement .




Notice: Do NOT remove the three bolts which hold the pump together.

2. Remove the oil pump bolts (205-207).



3. Remove the oil pump (200) from the valve body (300).
4. Inspect the oil pump. Refer to the Transmission/Transaxle/Transfer Case Unit Repair Manual.

1. Install the oil pump (200) to valve body (300).




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the oil pump bolts (205-207).

Tighten

•	Tighten the M6 X 1.0 X 20 bolt to 8 N·m (70 lb in).

•	Tighten the M6 X 1.0 X 85 bolt to 12 N·m (106 lb in).

•	Tighten the M6 X 1.0 X 95 bolt to 12 N·m (106 lb in).

3. Install the case side cover. Refer to Control Valve Body Cover Replacement .