For 1990-2009 cars only
Removal Procedure
- Disconnect the electrical connector from the intake air temperature (IAT) sensor.
- Remove the 3 bolts from the inner fender brace and remove the brace.
- Loosen the clamp securing the air intake duct to the air cleaner housing.
- Carefully remove the air intake duct from the throttle body and air cleaner housing (1).
- Remove the screws (2) from the air cleaner housing sections.
- Remove the air cleaner housing cover assembly (1).
- Without disconnecting the powertrain control module (PCM) connectors, remove the PCM (4) and the harness from the PCM housing (3).
- Carefully remove the PCM housing (1) by pulling the housing from the 2 rubber grommets in the engine compartment. Inspect the assembly for signs of damage and replace if necessary.
Installation Procedure
- Carefully reinstall the PCM housing by pushing the housing into the 2 rubber grommets (2) in the engine compartment.
- Carefully reinstall the PCM (4) and harness into the PCM housing (3).
- Reinstall the air cleaner housing cover assembly (1).
- Reinstall the screws (2) into the air cleaner housing sections.
- Carefully reinstall the air intake duct to the throttle body and air cleaner housing (1).
- Tighten the clamp securing the air intake duct to the air cleaner housing (1).
- Reposition the inner fender brace and reinstall the 3 bolts.
