GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Oldsmobile 🢒 2000 🢒 Intrigue 🢒 Engine 🢒 Engine Controls - 3.5L 🢒 Throttle Position Sensor Replacement

Removal Procedure
  1. Turn OFF the ignition.

    2. Object Number: 289014 Size: SH
  2. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement in Engine Mechanical.

    3. Object Number: 290670 Size: SH
  3. Remove the electrical connector (3) from the throttle position (TP) sensor (2).
  4. Remove the EGR valve. Refer to Exhaust Gas Recirculation Valve Replacement .

    5. Object Number: 255249 Size: SH
  5. Remove the 2 TP sensor mounting bolts (4) from the TP sensor (5).
  6. Remove the TP sensor (5) from the throttle body (7).
  7. Remove the O-ring (6) from the TP sensor (5).
  8. Discard the O-ring.

Installation Procedure

    Object Number: 255249 Size: SH
  1. Install the new O-ring (6) onto the TP sensor (5).
  2. Install the TP sensor (5) on to the throttle body (7).

    3. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the 2 TP sensor screws.

    4. Tighten
    Tighten the screws to 2.3  N·m (20  lb in).


    Object Number: 290670 Size: SH
  4. Install the electrical connector (3) to the TP sensor (2).
  5. Install the EGR valve. Refer to Exhaust Gas Recirculation Valve Replacement .

    6. Object Number: 289014 Size: SH
  6. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement in Engine Mechanical.