Removal Procedure
- Disconnect the electrical connector from the ignition control module.
- Remove the beauty cover (1). Lift at the end opposite the module to release the clip retainer from the ball pin on the cassette. Then slide the cover out of the slide latch in the module.
- Remove the 4 screws retaining the ignition control module to the coil cassette.
- Lift the module straight up off the cassette.
- Check that the mating connector and seal came off with the module. If not, remove the mating connector and seal from the cassette. With the mating connector removed, the cassette will have a female connector cavity with male pins.
Installation Procedure
Important: When replacing the ignition control module, use the following recommended
procedures:
• Ensure that the mating connector and seal are removed from the
coil cassette. • When installing a new module, insert the mating connector into
the module, install the seal, and apply dielectric grease to the terminals
on the mating connector prior to installing into the cassette. • Check all the connectors for any damaged terminals. • Clean all the mounting surfaces before re-installing any components.
- Install the ignition control module onto the coil cassette.
- Install the 4 screws that retain the ignition control module to the coil cassette.
- Install the beauty cover. Slide the latch tongue into the module while holding the opposite end slightly away from the coil cassette surface in order to clear and align the ball pin on the cassette with the clip retainer on the beauty cover. Press the clip retainer down onto the ball pin.
- Connect the electrical connector to the ignition control module.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the screws to 0.8 N·m (7.1 lb in).
