GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 182751  Size: SH
  1. Remove the instrument panel accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement in Instrument Panel, Gauges, and Console.
  2. Remove the bolts from the radio.
  3. Pull the radio toward you.

  4. Object Number: 182752  Size: SH
  5. Disconnect the electrical/audio connector from the rear of the radio.
  6. Disconnect the coaxial cable from the rear of the radio.
  7. Remove the radio from the instrument panel.

Installation Procedure


    Object Number: 182752  Size: SH
  1. Connect the coaxial cable to the rear of the radio.
  2. Connect the electrical/audio connector to the rear of the radio.
  3. Install the radio to the instrument panel.
  4. Important: If the radio locator tab is difficult to align to the IP locator opening, pull the radio toward you and reposition the antenna cable.

  5. Align the radio locator tab to the IP locator opening while pressing the radio into the instrument panel until fully seated.
  6. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.


    Object Number: 182751  Size: SH
  7. Install the bolts to the radio.
  8. Tighten
    Tighten the radio bolts to 3 N·m (25 lb in).

  9. Install the instrument panel accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement in Instrument Panel, Gauges and Console.