GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Oldsmobile 🢒 2000 🢒 Intrigue 🢒 Engine 🢒 Engine Electrical 🢒 Front Floor Console Replacement

Removal Procedure
  1. Remove the front floor console trim plate. Refer to Front Floor Console Trim Plate Replacement .

    2. Object Number: 289506 Size: SH
  2. Remove console shifter control trim plate bolts.

    3. Object Number: 289507 Size: SH
  3. Disconnect the required electrical connectors.
  4. Remove the screws from the front floor console mounting bracket at the rear of the transaxle shift lever.
  5. Open the front floor console armrest.
  6. Remove the mat from the front floor console storage compartment.
  7. Remove the screws from the front floor console mounting bracket at the rear storage compartment base.
  8. Remove the screws from the front floor console mounting at the front mounting point.
  9. Pull the front floor console rearward, up and out.
  10. Remove the front floor console from the vehicle.

Installation Procedure

    Object Number: 289507 Size: SH
  1. Align the front floor console to the floor.
  2. Connect the required electrical connectors.

    3. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the screws to the front floor console mounting bracket at the rear of the storage compartment base.

    4. Tighten
    Tighten the front floor console rear of storage compartment base screws to 6 N·m (53 lb in).

  4. Install the screws to the front floor console mounting bracket at the rear of the transaxle shift lever.

    5. Tighten
    Tighten the front floor console rear of transaxle shift lever screws to 6 N·m (53 lb in).

  5. Install the screws to the front floor console at the front mounting point.

    6. Tighten
    Tighten the front floor console front mounting point screws to 6 N·m (53 lb in).

  6. Install the mat to the front floor console storage compartment.

    7. Object Number: 289506 Size: SH
  7. Install console shifter control trim plate bolts.

    8. Tighten
    Tighten the console shift control trim plate bolts to 20 N·m (15 lb ft).

  8. Install the front floor console trim plate. Refer to Front Floor Console Trim Plate Replacement .
  9. Close the front floor console armrest.