GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Oldsmobile 🢒 2000 🢒 Intrigue 🢒 Body and Accessories 🢒 Lighting Systems 🢒 Headlamp Assembly or Headlamp Bulb and/or Cornering, Sidemarker, Park, Turn Signal Bulb Replacement

Removal Procedure

    Object Number: 182389 Size: SH
  1. Open the hood.
  2. Apply light pressure to the headlamp lens to hold the headlamp in place while removing the retainers.
  3. Lift up the headlamp retainers to release, then remove the retainers.
  4. Remove the headlamp mounting tabs from the slots in the upper fascia support and the fender reinforcement.

    5. Object Number: 182398 Size: SH
  5. Disconnect the electrical connector from the headlamp.
  6. Remove the headlamp.

    7. Object Number: 623845 Size: SH
  7. Remove the rubber access cover(s) from behind the headlamp bulb(s) to be replaced.

    8. Object Number: 623839 Size: SH
  8. Rotate the headlamp bulb base counterclockwise to release.
  9. Remove the headlamp bulb from the headlamp.

    10. Object Number: 623948 Size: SH
  10. Disconnect the electrical connector from the headlamp bulb.

Installation Procedure

    Object Number: 623948 Size: SH
  1. Connect the electrical connector to the headlamp bulb.

    2. Object Number: 623839 Size: SH
  2. Install the headlamp bulb to the headlamp.
  3. Rotate the headlamp bulb base clockwise to secure.

    4. Object Number: 623845 Size: SH
  4. Install the rubber access cover(s) to the headlamp.

    5. Object Number: 182398 Size: SH
  5. Connect the electrical connector to the headlamp.

    6. Object Number: 182389 Size: SH
  6. Position the headlamp mounting tabs to the slots in the upper fascia support and the fender reinforcement.
  7. Apply light pressure to the headlamp lens to hold the headlamp in place while installing the retainers.
  8. Align the headlamp retainers over the headlamp mounting tabs, then press the retainers down until fully seated.
  9. Inspect the headlamp for proper fit.
  10. Close the hood.
  11. Check the headlamp aim, If a new headlamp was installed, or if service or repairs in the front end area may have disturbed the headlamp mounting brackets. Refer to Headlamp Aiming .