GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Oldsmobile 🢒 2000 🢒 Intrigue 🢒 Body and Accessories 🢒 Theft Deterrent 🢒 Diagnostic System Check - Theft Deterrent

Diagnostic Aids

Use a J 35616-A when probing or checking electrical connector terminals. Refer to Testing for Intermittent Conditions and Poor Connections .

Test Description

The number(s) below refer to the step number(s) on the diagnostic table.

  1. Lack of communication may be due to a partial malfunction of the class 2 serial data circuit or due to a total malfunction of the class 2 serial data circuit. The specified procedure will determine the particular condition.

    2.

  2. The presence of DTCs which begin with "U" indicate some other module is not communicating. The specified procedure will compile all the available information before tests are performed.

Step

Action

Yes

No

1

Install a scan tool.

Does the scan tool power up?

Go to Step 2

Go to Scan Tool Does Not Power Up in Data Link Communications

2

  1. Turn ON the ignition, with the engine OFF.
  2. Attempt to establish communication with the following modules:
    3. • The body control module (BCM)
    • The powertrain control module (PCM)

Does the scan tool communicate with the BCM and PCM?

Go to Step 3

Go to Scan Tool Does Not Communicate with Class 2 Device in Data Link Communications

3

Select display DTCs function on the scan tool for the following modules:

    • The BCM
    • The PCM

Does the scan tool display any DTCs?

Go to Step 4

Go to Symptoms

4

Does the scan tool display any DTCs which begin with a "U"?

Go to Scan Tool Does Not Communicate with Class 2 Device in Data Link Communications

Go to Step 5

5

Does the scan tool display DTC B1000, B1013, or B1015?

Go to Diagnostic Trouble Code (DTC) List/Type in Body Control System

Go to Diagnostic Trouble Code (DTC) List/Type