GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Oldsmobile 🢒 1998 🢒 LSS 🢒 Restraints 🢒 Seat Belts 🢒 Seat Belt Replacement - Driver

Removal Procedure

    Caution: The seat belt assembly and/or bracket assembly must be replaced as a unit only. Do not substitute parts for any reason, or personal injury could result.

  1. Remove the center pillar trim. Refer to Center Pillar Garnish Molding Replacement in Interior Trim.

    2. Object Number: 195832 Size: SH
  2. Remove screws and slide track.
  3. Remove anchor bolt and guide loop.
  4. Remove screw and intermediate guide.
  5. Remove the carpet retainer. Move the seat forward in order to remove the anchor bolts.
  6. Remove dual retractor
  7. Remove the fasteners from the shoulder belt guide adjustment bracket assembly.
  8. Remove the shoulder belt guide adjustment bracket assembly.

Installation Procedure

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  1. Install two screws and the bracket assembly into center pillar near the roof.

    2. Tighten
    Tighten the screws to 25 N·m (19 lb ft)


    Object Number: 195832 Size: SH
  2. Install the anchor bolt for dual retractor into center pillar at rocker.

    3. Tighten
    Tighten the bolt to 42 N·m (31 lb ft).

  3. Install the anchor bolt for the guide loop into the bracket assembly.

    4. Tighten
    Tighten the bolt to 42 N·m (31 lb ft).

    Important: When installing slide track, care must be taken to engage the head of the guide loop into the socket on the back of the slide track (five positions of adjustment are provided). After the trim is installed a check should be made to see if the slide track locks into all five positions.

  4. Install the slide track and two fasteners.

    5. Tighten
    Tighten the fasteners to 1.9 N·m (16 lb in).

  5. Install the intermediate guide and fastener.

    6. Tighten
    Tighten the intermediate guide fastener to 1.9 N·m (16 lb in).

  6. Install the center pillar trim. Refer to Center Pillar Garnish Molding Replacement in Interior Trim.