HARD TO PRESS THROTTLE PEDAL SERVICE KIT FOR E2SE CARB.

MODELS/YEARS: 1982-86 CUTLESS CIERA AND OMEGA MODELS (VIN CODE X,Z)

Some 1982-86 vehicles equipped with the 2.8L V-6 engine and the model E2SE Varajet carburetor may exhibit a complaint of high effort required to depress the throttle pedal.

A service kit, part number 17111751, is now available to service this complaint. The service kit contains all the parts necessary to modify the carburetor, and an instruction sheet and illustration are included.

NOTICE: The pump lever attaching screw is self-tapping, and formed its own threads when it was installed at the factory. To avoid destroying the formed threads, the carburetor should be at room temperature before the pump lever attaching screw is removed.

(Numbers in parenthesis refer to Figure 1)

1. Remove air cleaner assembly.

2. Remove pump link retainer (13).

3. Remove pump lever attaching screw (A).

4. Disconnect pump lever (14) from pump link (68).

5. Hold throttle wide open and remove pump link (68) from throttle lever.

6. Remove throttle position sensor (TPS) plunger (32). - Discard pump link retainer, pump lever attaching screw, lever, link, and TPS plunger.

7. Install new TPS plunger (32).

8. Hold throttle wide open and install new pump link (68) in throttle lever.

9. Connect new pump lever (14) to pump link and install with new pump lever attaching screw (A). - Tighten attaching screw to 6.8 N.m (60 lbs. in.).

10. Adjust TPS following procedure found in Section 6C3 (1982-83), or Section 6E1, "Driveability and Emissions-Carbureted", of the 1984, 1986 Service Manual.

11. Install air cleaner assembly.

WARRANTY INFORMATION

Labor Operation Number: T1169

Labor Time: .9 hrs.

Trouble Code: 92

.

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.