GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Oldsmobile 🢒 2001 🢒 Silhouette Ext. 🢒 Brakes 🢒 Antilock Brake System 🢒 Rear Wheel Speed Sensor Replacement

Removal Procedure

    Object Number: 561883 Size: SH

    Important: The rear wheel speed sensors and rings are integral with the hub and bearing assemblies.

    If a speed sensor or a ring needs replacement, replace the entire hub and bearing assembly. Refer to Rear Wheel Bearing and Hub Replacement in Rear Suspension.

  1. Raise and support the vehicle on a suitable hoist. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  3. Remove the rear wheel speed sensor electrical connector located next to the rear strut.

    4. Object Number: 230412 Size: SH
  4. Remove the hub and bearing assembly (1). Refer to Rear Wheel Bearing and Hub Replacement in Rear Suspension.

Installation Procedure

    Object Number: 230412 Size: SH
  1. Install the hub and bearing assembly (1) to the vehicle. Refer to Rear Wheel Bearing and Hub Replacement in Rear Suspension.

    2. Object Number: 561883 Size: SH
  2. Install the rear wheel speed sensor electrical connector.
  3. Install the wheel and tire assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  4. Lower the vehicle.
  5. Turn the ignition switch to the RUN position with the engine off.
  6. Perform Diagnostic system check. Refer to Diagnostic System Check - ABS .