Tools Required
J 38778 Door Trim
Pad Clip and Garnish Trim Clip Remover
Removal Procedure
- Remove the overhead console
from the video entertainment system. Refer to
VES Overhead Console Support Bracket Replacement
.
- Insert J 38778
between the video entertainment support bracket (1) and the video screen
assembly (2) at the pin locations. Pull downward in order to break
the pins.
- Disconnect the video screen
electrical connectors (1, 4, 5).
Installation Procedure
- Connect the video screen
electrical connectors (1, 4, 5).
- Install the video screen
to the support bracket. Hold the video screen in place while installing the
overhead console.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install 4 center
screws to the video screen and console.
Tighten
Tighten the screws to 2 N·m (18 lb in).
- Install the video entertainment system overhead console. Refer
to
VES Overhead Console Support Bracket Replacement
.