GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Oldsmobile 🢒 2001 🢒 Silhouette Ext. 🢒 Body and Accessories 🢒 Seats 🢒 Memory Seat Control Module Replacement

Removal Procedure

    Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:

       • Air bag deployment
       • Personal injury
       • Unnecessary SIR system repairs
    In order to avoid the above conditions, observe the following guidelines:
       • Refer to SIR Component Views in order to determine if you are performing service on or near the SIR components or the SIR wiring.
       • If you are performing service on or near the SIR components or the SIR wiring, disable the SIR system. Refer to Disabling the SIR System.

  1. Disable the SIR system. Refer to Disabling the SIR System in SIR.
  2. Remove the seat.

    3. Object Number: 740755 Size: SH
  3. Disconnect the electrical connectors.
  4. Using a flat-bladed tool, gently pry the memory seat control module from the bracket slots.

    5. Object Number: 740757 Size: SH
  5. Slide the module toward the rear of the seat.

Installation Procedure

    Object Number: 740757 Size: SH
  1. Slide the module into the mounting bracket and push until the module is fully seated.

    2. Object Number: 740755 Size: SH
  2. Connect the electrical connectors.
  3. Install the drivers seat.
  4. Enable the SIR system. Refer to Enabling the SIR System in SIR.
  5. Calibrate the seat. Refer to Memory Seat Calibration .