- Install the engine front cover gasket.
- Apply sealer GM P/N 12346004, (Canadian P/N 10953480) or equivalent to both sides of the lower tabs of the engine front cover gasket, and the engine front cover bolts. Apply the sealer no less than 5.0 mm (0.20 in) wide.
- Install the engine front cover.
- Install the engine front cover bolts (2).
- Install the engine front cover bolts (3).
- Install the engine front cover bolts (1).
- Install the crankshaft position sensor wiring bracket.
- Install the crankshaft position sensor wiring bracket bolt.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the engine front cover bolts (2) to 55 N·m
(41 lb ft).
Tighten
Tighten the engine front cover bolts (3) to 55 N·m
(41 lb ft).
Tighten
Tighten the engine front cover bolts (1) to 27 N·m
(20 lb ft).
Tighten
Tighten the crankshaft position sensor wiring bracket
bolt to 27 N·m (20 lb ft).
