GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

    Caution: For safety reasons, the Brake Pressure Modulator Valve (BPMV) must not be repaired; the complete unit must be replaced. With the exception of the EBCM/EBTCM, no screws may be loosened. If screws are loosened, it will not be possible to get the brake circuits leak-tight and personal injury may result.

    Caution: Brake fluid may irritate eyes and skin. In case of contact, take the following actions:

       • Eye contact - rinse thoroughly with water.
       • Skin contact - rinse with soap and water.
       • If ingested - consult a physician immediately.

    Notice: Avoid spilling brake fluid on any of the vehicle's painted surfaces, wiring, cables or electrical connectors. Brake fluid will damage paint and electrical connections. If any fluid is spilled on the vehicle, immediately flush the area with water to minimize the potential for damage.

    Notice: To prevent equipment damage, never connect or disconnect the wiring harness connection from the EBCM with the ignition switch in the ON position.

  1. Turn the ignition to Off.
  2. Remove the engine coolant reservoir. Refer to Radiator Surge Tank Replacement .
  3. Remove the underhood fuse center.
  4. Clean the brake pipe fittings at the brake pressure modulator valve (BMPV) assembly.

  5. Object Number: 1797638  Size: SH
  6. Disconnect the electronic brake control module (EBCM) connector (2).
  7. Place a shop towel under the BPMV to catch any fluid loss.
  8. Note the position of the brake pipes, then remove the brake pipes from the brake pressure modulator valve (BMPV) assembly (1).
  9. Plug the brake pipe openings.

  10. Object Number: 1797641  Size: SH
  11. Remove the BPMV mounting bracket bolt (2) and nuts (3).
  12. Remove the BPMV and mounting bracket assembly (1).
  13. Remove the BPMV assembly from the mounting bracket.

Installation Procedure

  1. Install the BPMV assembly into the mounting bracket. Secure with bolts.
  2. Tighten
    Tighten the nuts to 11 N·m (8 lb ft).

    Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 1797641  Size: SH
  3. Install the BPMV and mounting bracket assembly (1). Secure with bolt (2) and nuts (3).
  4. Tighten
    Tighten the nuts to 10 N·m (89 lb in).


    Object Number: 1797638  Size: SH
  5. Remove the plugs from the brake pipes and connect the brake pipes to the BPMV assembly.
  6. Tighten
    Tighten the brake pipe nuts to 16 N·m (12 lb ft).

  7. Connect the electronic brake control module (EBCM) connector (2).
  8. Install the underhood fuse center.
  9. Install the engine coolant reservoir. Refer to Radiator Surge Tank Replacement .
  10. Bleed the brake system. Refer to Hydraulic Brake System Bleeding .
  11. Perform the Diagnostic System Check - Vehicle .Refer to Control Module References for programming and setup information.