Diagnostic Instructions
DTC Descriptor
DTC P0313: Misfire Detected With Low Fuel Level
Circuit/System Description
DTC P0313 indicates that an engine misfire has occurred during a low fuel condition.
Conditions for Running the DTC
• | DTCs P0016, P0106, P0107, P0108, P0117, P0118, P0121, P0122, P0123, P0221, P0222, and P0223 are not set. |
• | Engine speed is between 600-6,500 RPM. |
• | The ignition 1 voltage is greater than 11 volts. |
• | The engine coolant temperature (ECT) is between -7 and +120°C (+19 and +248°F). |
• | The A/C compressor clutch is not changing states. |
• | The torque management is not active. |
• | The fuel tank level is more than 15 percent. |
• | The ECM is not in fuel cut-off or decel fuel cut-off mode. |
• | The ECM is not receiving a rough road signal. |
• | The throttle angle is steady. |
• | The transmission is not changing gears. |
• | The antilock brake system (ABS) and the traction control system (TCS), if equipped, is not active. |
• | The DTC runs continuously when the above conditions are met. |
Conditions for Setting the DTC
The ECM detects a crankshaft rotation speed variation indicating a misfire rate sufficient to cause emissions levels to exceed a predetermined value.
Action Taken When the DTC Sets
DTC P0313 is a Type C DTC.
Conditions for Clearing the DTC
DTC P0313 is a Type C DTC.
Reference Information
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions
Scan Tool Reference
Circuit/System Verification
- DTC P0313 is an informational DTC only. Correct the engine misfire DTCs that are set, refer to
Diagnostic Trouble Code (DTC) List - Vehicle
.
- If the vehicle passes the Circuit/System Verification Test, then operate the vehicle within the conditions for running the DTC. You may also operate the vehicle within the conditions that are captured in the Freeze Frame/Failure Records List.