For 1990-2009 cars only
Stop Lamps Remain On (Adjust Stop Lamp Switch)
| Subject: | Stop Lamps Remain On (Adjust Stop Lamp Switch) |
| Models: | 2007 Chevrolet Captiva (Export Only) |
| 2007 Holden Captiva, Captiva MAXX (Export Only) |
| 2007 Opel Antara (Export Only) |
Condition
Some customers may comment that the stop lamps (rear brake lights) remain on or that the brakes activate (apply) without stepping on the brake pedal.
Cause
This condition may be caused by a misadjusted stop lamp switch.
Correction
Do NOT replace the stop lamp switch.
Adjust the stop lamp switch rod by performing the procedure in this bulletin.
- Remove the stop lamp switch. Refer to Stop Lamp Switch Replacement in SI.
- Insert the stop lamp switch into the switch holder (1).
- Push the stop lamp switch into the switch bracket (2) until the stop lamp switch rod makes contact with the switch stopper (3).
- Push and turn the switch 90 degrees clockwise.
- Inspect the length of the stop lamp switch rod (4). The length should be 0.2-1.2 mm (0.008-0.05 in).
Important: The extended length of the stop lamp switch rod should be 0.2-1.2 mm (0.008-0.05 in).
Warranty Information
For vehicles repaired under warranty, use:
Labor Operation | Description | Labor Time |
|---|---|---|
N2440 (WINS) | Switch - Stop Lamp - Replace | Use Published Labor Operation Time |
N207500 (NEWS) | ||
4280700 (GMDAT) |
