Removal Procedure
Caution: Refer to Battery Disconnect Caution in the Preface section.
- Disconnect the negative battery cable.
- Remove the engine cover. Refer to
Engine Cover Replacement.
- Disconnect the mass air flow (MAP) sensor connector.
- Remove the air cleaner assembly bolts.
- Remove the turbocharger inlet duct bolt and clamp.
- Remove the air cleaner assembly and turbocharger duct.
- Remove the charge air cooler inlet pipe bolts.
- Remove the charge air cooler inlet pipe.
- Disconnect the PCV hose and clamp from the turbocharger inlet elbow.
- Remove the turbocharger inlet elbow.
- Remove the turbocharger outlet duct.
- Remove the charge air cooler inlet/outlet clamps and electric throttle control (ETC) side clamp.
- Remove the charge air cooler inlet/outlet hoses.
Installation Procedure
- Install the charge air cooler inlet/outlet hoses.
- Install the turbocharger inlet elbow and outlet duct.
Notice: Refer to Fastener Notice in the Preface section.
- Install the charge air cooler inlet pipe.
Tighten
Tighten the charge air cooler inlet pipe bolts to 8 N·m (70.8 lb in).
- Install the air cleaner assembly and the turbocharger inlet duct.
Tighten
• | Tighten the air cleaner assembly bolts to 6 N·m (53 lb in) |
• | Tighten the turbocharger inlet duct bolt to 3 N·m (26.6 lb in). |