GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Opel 🢒 2008 🢒 Antara 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Intake Manifold Runner Control Solenoid Replacement

Removal Procedure

    Caution: Refer to Battery Disconnect Caution in the Preface section.


    Object Number: 1795375 Size: SH
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Disconnect the intake manifold tuning control (IMTC) solenoid valve connector.

    3. Object Number: 1804698 Size: SH
  3. Remove the upper intake manifold assembly. Refer to Engine Oil Pressure Sensor and/or Switch Replacement .
  4. Remove the three bolts, attaching the IMTC solenoid valve to the upper intake manifold.
  5. Remove the IMTC solenoid valve from the upper intake manifold by first twisting the solenoid valve to release it, and then pulling the solenoid valve away from the manifold.

Installation Procedure

    Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 1804698 Size: SH

    Important: Ensure the IMTC solenoid valve is fully seated before tightening the attaching bolt to the specified torque.

  1. Install the IMTC solenoid valve to the upper intake manifold.

    2. Tighten
    Tighten the intake manifold tuning control solenoid valve attaching bolts to 10 N·m (89 lb in).

  2. Install the upper intake manifold. Refer to Upper Intake Manifold Replacement .
  3. Connect the IMTC solenoid valve connector.
  4. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .