The engine coolant temperature (ECT) sensor is a variable resistor that measures the temperature of the engine coolant. The engine control module (ECM) supplies 5 volts to the ECT signal circuit and supplies a ground to the low reference circuit. The ECM monitors the performance of the ECT sensor. If the ECM detects excessive noise or rapid fluctuations in the ECT signal, this DTC sets.

The following table illustrates the difference between temperature, resistance, and voltage:

DTC P0119 is a Type B DTC.

DTC P0119 is a Type B DTC.

Schematic Reference

Engine Controls Schematics

Connector End View Reference

Component Connector End Views

Electrical Information Reference

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions

Scan Tool Reference

Control Module References for scan tool information

1. Observe the scan tool engine coolant temperature (ECT) sensor parameter while moving the ECT sensor connector and the engine control module (ECM) connector. The ECT sensor parameter should not fluctuate while moving the related harnesses and connectors.

⇒	Repair the suspected harness or connection if the ECT parameter fluctuates greater than 3°C (5°F) while moving the related harnesses and connectors.

2. Inspect the engine coolant level. Verify that the cooling system is operating correctly.

⇒	If you suspect a condition with engine cooling system, refer to Symptoms - Engine Cooling .

3. Operate the vehicle within the conditions for running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that are captured in the Freeze Frame/Failure Records Data List.

1. Ignition OFF, disconnect the harness connector at the engine coolant temperature (ECT) sensor.

Notice: Do NOT use a test lamp to test the continuity of the circuit. Damage to the control module may occur due to excessive current draw.

Important: The control module or the sensor may be damaged if the circuit is shorted to B+.

2. Ignition ON, test for less than 1 volt between the low reference circuit terminal 2 and ground.

⇒	If greater than the specified range, test the low reference circuit for a short to voltage. If the circuit tests normal, replace the ECM.

3. Ignition OFF, remove the fuse that supplies B+ to circuit terminal X2-56 of the ECM.
4. Test for less than 5 ohms between the low reference circuit terminal 2 and ground.

⇒	If greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the ECM.

5. Install the fuse that supplies B+ to circuit terminal X2-56 of the ECM.
6. Ignition ON, verify that the scan tool ECT sensor parameter is at -40°C (-40°F).

⇒	If greater than the specified range, test the signal circuit for a short to ground. If the circuit tests normal, replace the engine control module (ECM).

Important: If the fuse in the jumper wire opens, the signal circuit is shorted to a voltage and the sensor may be damaged.

7. Ignition ON, install a 3A fused jumper wire between the signal circuit and the low reference circuit. Verify the scan tool ECT sensor parameter is greater than 142°C (288°F).

⇒	If less than the specified range, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the ECM.

8. If all circuits test normal, test or replace the ECT sensor.

1. Ignition OFF, disconnect the harness connector at the engine coolant temperature (ECT) sensor.

Important: A thermometer can be used to test the sensor off the vehicle.

2. Test the ECT sensor by varying the sensor temperature while monitoring the sensor resistance. Compare the readings with the Temperature Versus Resistance - Engine Coolant Temperature Sensor table and verify that the resistance is within 5 percent of the specification.

⇒	If not within the specified range, replace the ECT sensor.

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.