Removal Procedure
Caution: Refer to Battery Disconnect Caution in the Preface section.
- Disconnect the negative battery cable.
- Remove the left front seat. Refer to
Bucket Seat Replacement
.
- Disconnect the electrical connector from the inclination sensor.
- Remove the inclination sensor from the bracket by sliding the sensor rearward.
- Remove the bracket by removing the bolts, if needed.
Installation Procedure
Notice: Refer to Fastener Notice in the Preface section.
- Install the inclination sensor in the bracket with bolts (1).
Tighten
Tighten the inclination sensor bracket bolts to 10 N m (7 lb ft).
- Install the inclination sensor on the bracket.
- Connect the connector of inclination sensor.
- Install the left front seat. Refer to
Bucket Seat Replacement
.
- Connect the negative battery cable.