Removal Procedure
Warning: Refer to Battery Disconnect Warning in the Preface section.
- Disconnect the negative battery cable.
- Disconnect the mass air flow (MAF) sensor connector.
- Loosen the clamp and disconnect the flexible air intake duct from the MAF sensor assembly.
- Remove the air cleaner housing bolts.
- Unclip the housing from the ball stud and then remove the air cleaner assembly.
Installation Procedure
- Install the air cleaner lower housing to the ball stud.
Caution: Refer to Fastener Caution in the Preface section.
- Install the air cleaner housing bolts and tighten to
6 N·m (53 lb in).
- Install the air intake duct assembly.
- Tighten the loosened clamps.