For 1990-2009 cars only
Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC C0899: Device Voltage LowCircuit/System Description
The electronic brake control module (EBCM) monitors the battery voltage level available for system operation. A low voltage condition prevents the system from operating properly.
Conditions for Running the DTC
The ignition is ON.
Conditions for Setting the DTC
This fault will be set if the battery voltage to EBCM is less than 10 volts for 200 msec.
Action Taken When the DTC Sets
The ABS indicator turns ON until the voltage returns to above 10 volts.
Conditions for Clearing the DTC
| • | The condition for the DTC is no longer present. |
| • | The EBCM automatically clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles. |
Reference Information
Schematic Reference
Antilock Brake System Schematics
Connector End View Reference
Antilock Brake System Connector End Views
Description and Operation
Electrical Information Reference
Scan Tool Reference
Scan Tool Data List for EBCM
Circuit/System Testing
- Measure the voltage at the battery terminals.
- With scan tool, read the battery voltage in the EBCM data list.
- Go to Battery Inspection/Test and Charging System Test .
| ⇒ | If less than 10 volt, test the ground circuit of the EBCM for high resistance. If the circuit test normal, test or replace the EBCM. |
Repair Instructions
Perform the Diagnostic Repair Verification After completing the diagnostic procedure.
| • | Control Module References for EBCM replacement, setup, and programming |
