Checking Engine Oil
It is a good idea to check the engine oil level at each fuel fill. In order to get an accurate reading, the oil must be warm and the vehicle must be on level ground.
The engine oil dipstick handle is a yellow loop. See Engine Compartment Overview for the location of the engine oil dipstick.
- Turn off the engine and give the oil several minutes to drain back into the oil pan. If this is not done, the oil dipstick might not show the actual level.
- Pull the dipstick and clean it with a paper towel or cloth, then push it back in all the way. Remove it again, keeping the tip down and check the level.
When to Add Engine Oil
If the oil is below the MIN (minimum) mark, add at least one quart/liter of the recommended oil. This section explains what kind of oil to use. For engine oil crankcase capacity, see Capacities and Specifications.
Notice: Do not add too much oil. If the engine has so much oil that the oil level gets above the upper mark that shows the proper operating range, the engine could be damaged.
See Engine Compartment Overview for the location of the engine oil fill cap.
Add enough oil to put the level somewhere in the proper operating range. Push the dipstick all the way back in when through.
What Kind of Engine Oil to Use
Look for three things:
| • | GM4718M |
| This vehicle's engine requires a special oil meeting standard GM4718M, such as Mobil 1® or equivalent. Oils meeting this standard may be identified as synthetic. However, not all synthetic oils will meet this standard. Use only an oil that meets standard GM4718M. |
| Notice: Using oils that do not have the GM4718M Standard designation can cause engine damage not covered by the vehicle warranty. |
| • | SAE 5W-30 |
| SAE 5W-30 is best for the vehicle. These numbers on an oil container show its viscosity, or thickness. Do not use other viscosity oils such as SAE 20W-50. |
| • | American Petroleum Institute (API) starburst symbol |
Oils meeting these requirements should have the starburst symbol on the container. This symbol indicates that the oil has been certified by the American Petroleum Institute (API).
This vehicle's engine was filled at the factory with a synthetic oil meeting all requirements for this vehicle.
Substitute Engine Oil: When adding oil to maintain engine oil level, oil meeting standard GM4718M might not be available. You can add substitute oil designated SAE 5W-30 with the starburst symbol at all temperatures. Substitute oil not meeting standard GM4718M should not be used for an oil change.
Engine Oil Additives / Engine Oil Flushes
Do not add anything to the oil. The recommended oils with the starburst symbol that meet standard GM4718M are all that is needed for good performance and engine protection.
Engine oil system flushes are not recommended and could cause engine damage not covered by the vehicle warranty.
