For 1990-2009 cars only
Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC C0900: Device Voltage HighDiagnostic Fault Information
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
|---|---|---|---|---|
B+ | C0899 | C0899 | -- | -- |
Ground | -- | C0899 | -- | -- |
Circuit/System Description
The electronic brake control module (EBCM) monitors the ignition voltage. If the voltage level is too high, damage may result in the system. When a high voltage condition is detected the EBCM turns OFF the system relay which removes battery voltage from the solenoid valves and pump motor.
Conditions for Running the DTC
Engine running.
Conditions for Setting the DTC
The system voltage is greater than 16 volts for 100 msec.
Action Taken When the DTC Sets
| • | Traction Control System (TCS) and Vehicle Stability Enhancement System (VSES) disabled for the duration of the ignition cycle. |
| • | ABS disabled if ignition voltage exceeds 19.5 volts. |
| • | The TCS indicator turns ON. |
| • | The Antilock Brake System (ABS) indicator turns ON if voltage exceeds 19.5 volts. |
Conditions for Clearing the DTC
| • | The condition for the DTC is no longer present. |
| • | The EBCM automatically clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles. |
Diagnostic Aids
| • | A possible cause of this DTC could be overcharging with a battery charger or jump starting. |
| • | A high voltage value in multiple modules indicates a concern in the charging system. |
Reference Information
Schematic Reference
Antilock Brake System Schematics
Connector End View Reference
Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information.
Circuit/System Verification
- Engine running measure and record the voltage at the battery terminals. Verify that the battery voltage is 12.6-15.5 volts.
- Engine running, observe the scan tool EBCM battery positive voltage parameter. The reading should be between 12.6 and 15.5 volts.
| ⇒ | If the battery voltage is not within the specified range, refer to Charging System Test |
| ⇒ | If not within the specified range, replace the EBCM. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for EBCM replacement, setup and programming.
