Camshaft Cover Installation LDK

1. Install NEW camshaft cover grommets and camshaft cover bolts if they are serviced with the grommets.
2. Assemble the camshaft cover (1) and NEW gasket. Ensure that the gasket is located in the retaining groove in the camshaft cover.
3. Install the cover on the cylinder head and hand start the bolts.

Caution: Refer to Fastener Caution in the Preface section.




4. Install the ignition coils (4). Tighten the ignition coil bolts (3) to 10 N·m (89 lb in).
5. Tighten the camshaft cover bolts to 10 N·m (89 lb in).

Note: The solenoid valves are marked intake and exhaust.

6. Install the camshaft position actuator solenoid valves (2).
7. Install the camshaft position actuator solenoid valve bolts (1) and tighten to 10 N·m 89 lb in.



8. Install the camshaft housing cover insulator (1) and bolts. Tighten the camshaft housing cover insulator bolts to 10 N·m (89 lb in).



9. Install the front lift bracket (1).
10. Install the front lift bracket bolts and tighten to 25 N·m (18 lb ft).



11. Install the rear lift bracket (1).
12. Install the rear lift bracket bolts and tighten to 25 N·m (18 lb ft).