Starter Replacement. Opel Insignia HB (Global Epsilon) 2009

For 1990-2009 cars only

Makes 🢒 Opel 🢒 2009 🢒 Insignia HB (Global Epsilon) 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Starter Replacement

Starter Replacement 2.0L Diesel

Callout	Component Name
Preliminary Procedures Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection. Remove the engine shield. Refer to Engine Shield Replacement.
1	Battery Cable Fastener (Qty: 3) Caution: Refer to Fastener Caution in the Preface section. Procedure Remove the cable from the starter motor. Tighten 8 N·m (71 lb in)
2	Starter Motor Fastener (Qty: 3) Tighten 22 N·m (16 lb in)
3	Starter Motor

Callout	Component Name
Preliminary Procedure Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection.
1	Battery Cable Fastener (Qty: 2) Caution: Refer to Fastener Caution in the Preface section. Tighten X N·m (X lb in)
2	Starter Motor Retainer
3	Starter Motor Fastener (Qty: 2) Tighten X N·m (X lb in)
4	Starter Motor Procedure Disconnect any electrical connectors.

Callout

Component Name

Starter Motor Wiring Harness (Qty: 3)

Starter Fastener (Qty: 2)

Caution: Refer to Fastener Caution in the Preface section.

Tip

•	Remove the upper starter fastening bolt before lifting the vehicle.

•	Disconnect the crankshaft position sensor electrical connector. Remove the connector from the bracket.

Tighten
25 N·m (18 lb ft)

Starter Motor

Callout	Component Name
Preliminary Procedure Remove secondary air injection pump. Refer to LINK.
1	Starter Motor Wiring Harness Fastener Procedure Disconnect the electrical connector of the knock sensor. Caution: Refer to Fastener Caution in the Preface section. Tighten X N·m (X lb ft)
2	Starter Motor Wiring Harness Fastener Tighten X N·m (X lb ft)
3	Starter Fastener (Qty: 2) Tighten 47 N·m (34 lb ft)
4	Starter Motor