• | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
• | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
• | Diagnostic Procedure Instructions provide an overview of each diagnostic category. |
The electric parking brake control module has an internal motor, apply actuator, release actuator, and temperature sensor. The electric parking brake control module also contains the logic for applying and releasing the parking brake when commanded by the electric parking brake switch. When the electric parking brake control module receives a signal from the switch the internal circuit board temperature is checked to verify it is within operating range before the control module performs the requested operation.
Ignition OFF, ACCESSORY, or RUN mode.
The electric parking brake control module detects an internal motor malfunction.
• | The electric parking brake is disabled. |
• | A message and/or a warning indicator may be displayed. |
• | The electric parking brake control module clears the history DTC when a current DTC is not detected in 40 ignition cycles. |
• | The condition for the DTC is no longer present. |
Electronic Parking Brake Control Module Description
Control Module References for scan tool information
Remove the EPB fuse and reinstall. Verify DTC C028A is not set.
⇒ | If DTC is set, replace the K83 Electric Parking Brake Control Module. |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for electric parking brake control module replacement, setup, and programming.