Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC B096B 02: Parking Aid Switch Parallel Parking Circuit Short to GroundDiagnostic Fault Information
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
|---|---|---|---|---|
Parallel Park Assist Switch Signal | B096B 02 | 1 | -- | -- |
Parallel Parking Assist Switch Ground | -- | 1 | -- | -- |
1. Parallel Parking Assist Switch Malfunction | ||||
Circuit/System Description
The parallel parking assist can be activated / deactivated by pressing the parallel parking assist switch.
Conditions for Running the DTC
| • | Ignition ON |
| • | The parallel parking assist is activated. The activation takes place through pressing the parallel parking assist switch. |
Conditions for Setting the DTC
The object alarm module has detected a short to ground.
Action Taken When the DTC Sets
| • | The parallel parking assist is disabled. |
| • | An indicator in the driver information center shows the parking assistance is not available. |
Conditions for Clearing the DTC
The condition for setting the DTC is no longer present.
Reference Information
Schematic Reference
LINK 142605
Connector End View Reference
Description and Operation
Object Detection Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
Activate and deactivate the parallel park assist switch and verify the scan tool Advanced Park Assist Switch parameter changes between Active and Inactive.
Circuit/System Testing
- Ignition OFF, disconnect the X1 harness connector at the K41 Object Alarm Module.
- Test for infinite resistance between the input signal circuit terminal 6 (X1) at the K41 Object Alarm Module harness connector and ground.
- If all circuits test normal, replace the K41 Object Alarm Module.
| ⇒ | If less than the specified range, test input signal circuit for a short to ground. If the circuit tests normal, replace the S48D Multifunction Switch - I/P 2. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
| • | Control Module References for Object Alarm Module replacement, setup and programming |
