The engine control module (ECM) provides ignition voltage to the coil side of the fuel pump relay whenever the engine is cranking or running. The ECM enables the fuel pump relay as long as the engine is cranking or running, and ignition system reference pulses are received. If no ignition system reference pulses are received, the ECM turns OFF the fuel pump. The fuel pump relay control circuit is equipped with a feedback circuit that is pulled up to voltage within the ECM. The ECM can determine if the control circuit is open, shorted to ground, or shorted to a voltage by monitoring the feedback voltage.

The ECM detects that the fuel pump relay control circuit temperature is too high for greater than 1 s.

DTC P062A is a Type A DTC.

DTC P062A is a Type A DTC.

Schematic Reference

Engine Controls Schematics

Connector End View Reference

Component Connector End Views

Electrical Information Reference

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions

Scan Tool Reference

Control Module References for scan tool information

1. Ignition ON, command the Fuel Pump Relay ON and OFF with a scan tool. You should hear and feel an audible click.
2. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.

1. Ignition OFF, disconnect the KR23A Fuel Pump Relay.
2. Test for less than 5 Ω between the ground circuit terminal 9 X3 and ground

⇒	If greater than the specified range, test the ground circuit for an open/high resistance

3. Connect a test lamp between the control circuit terminal 13 X3 and ground.
4. Ignition ON, command the Fuel Pump Relay ON and OFF with a scan tool. The test lamp should turn ON and OFF when changing between the commanded states.

⇒	If the test lamp is always ON, test the control circuit for a short to voltage. If the circuit tests normal, replace the K20 Engine Control Module (ECM).

⇒	If the test lamp is always OFF, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the K20 Engine Control Module (ECM).

5. If all circuits test normal, test or replace the KR23A Fuel Pump Relay.

1. Ignition OFF, disconnect the fuel pump relay.
2. Test for 70-110 Ω of resistance between terminals 85 and 86.

⇒	If not within the specified range, replace the KR23A Fuel Pump Relay.

3. Test for infinite resistance between the following terminals:

•

30 and 86

•

30 and 87

•

30 and 85

•

85 and 87

⇒	If not the specified value, replace the KR23A Fuel Pump Relay.

4. Install a 20 A fused jumper wire between relay terminal 85 and B+. Install a jumper wire between relay terminal 86 and ground. Test for less than 2 Ω between terminals 30 and 87.

⇒	If greater than the specified range, replace the KR23A Fuel Pump Relay.

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

Control Module References for ECM replacement, setup, and programming