Clutch Release Bearing Replacement LDE/A16XER, 2H0/A18XER

1. Remove the transmission. Refer to LINK.



2. Remove pressure line fastening sleeve (1).

•	Unlatch fastening sleeve for pressure line on clutch housing (arrows).

•	Draw fastening sleeve out of transmission slightly.

•	Detach fastening sleeve for pressure line.

•	Carefully unlatch 2x retaining lug (3).




3. Remove central release (1) with hydraulic line.

Remove 3x fasteners (arrow).

1. Clean 3x thread (1) in transmission.

Note: Note installation position.

2. Install fastening sleeve for pressure line.




Note: Use new bolts.

It is essential to avoid pulling the central release at an angle.
3. Install central release (1) with hydraulic line.

•	Clip hydraulic line in sleeve.

•	Lightly coat seal ring in central release with transmission fluid.

•	Preassemble 3 fasteners evenly in contact with the flange.

•	Tighten the 3 fasteners from central release (arrow) to 6 N·m (53.1 lb in).

4. Install the transmission. Refer to LINK.