For 1990-2009 cars only
Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC C0267 00: Low Brake Fluid IndicatedDiagnostic Fault Information
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
|---|---|---|---|---|
Signal | C0267 00 | -- | -- | -- |
Ground | -- | -- | -- | -- |
Circuit/System Description
The brake fluid level switch monitors the level of brake fluid in the brake fluid reservoir. When the electronic brake control module (EBCM) sees the brake fluid level switch input closed, the DTC is set.
Conditions for Running the DTC
Ignition ON
Conditions for Setting the DTC
| • | A short to ground is detected on the brake fluid level signal circuit for 5 s. |
| • | Low brake fluid level is detected for 5 s. |
Conditions for Clearing the DTC
The condition for setting the DTC is no longer present.
Reference Information
Schematic Reference
Connector End View Reference
Description and Operation
Hydraulic Brake System Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
- Inspect for proper brake fluid level. The fluid level should be above minimum level.
- Ignition ON, observe the scan tool Brake Fluid Level Sensor parameter. The reading should be OK.
| ⇒ | If low, refer to Brake Fluid Loss. |
Circuit/System Testing
- Ignition OFF, disconnect the harness connector at the B20 Brake Fluid Level Switch.
- Test for less than 5 Ω between the ground circuit terminal 2 and ground.
- Ignition ON, verify the scan tool Brake Fluid Level Sensor parameter is OK.
- Install a 3 A fused jumper wire between the signal circuit terminal 1 and ground.
- Verify the scan tool Brake Fluid Level Sensor parameter is Low.
- If all circuits test normal, test or replace the B20 Brake Fluid Level Switch.
| ⇒ | If greater than the specified value, test the ground circuit for an open/high resistance. |
| ⇒ | If not the specified value, test the signal circuit for a short to ground. If the circuit tests normal, replace the K17 Electronic Brake Control Module (EBCM). |
| ⇒ | If not the specified value, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the K17 Electronic Brake Control Module (EBCM). |
Component Testing
Static Test
- Ignition OFF, disconnect the harness connector at the B20 Brake Fluid Level Switch.
- Test for infinite resistance between the ground circuit terminal 2 and the signal circuit terminal 1.
| ⇒ | If less than the specified value, replace the B20 Brake Fluid Level Switch. |
Repair Instructions
| • | Perform the Diagnostic Repair Verification after completing the diagnostic procedure. |
| • | Control Module References for EBCM replacement, setup and programming |
