Was the Wiper/Washer System Check performed?

--

Go to Step 2

Go to Wiper/Washer System Check

1. Turn the ignition switch to RUN.
2. Turn the wiper switch to OFF.
3. Disconnect the wiper/washer switch connector C201.

Do the wipers park?

--

Go to Step 3

Go to Step 4

Replace the wiper/washer switch. Refer to Multifunction, Turn Signal, and Hazard Switch Replacement - On Vehicle .

Is the replacement complete?

--

Go to Wiper/Washer System Check

--

Measure the voltage from connector C201 (vehicle side), terminal B, to ground with a DMM.

Is the measurement greater than the specified voltage?

1.0 V

Go to Step 6

Go to Step 5

Replace the wiper motor cover. Refer to Wiper Motor Cover Replacement .

Is the replacement complete?

--

Go to Wiper/Washer System Check

--

1. Reconnect the wiper/washer switch connector C203.
2. Disconnect the wiper motor connector.
3. Measure the voltage from the wiper motor connector, terminal D, to ground with a digital voltmeter.

Is the measurement greater than the specified value?

1.0 V

Go to Step 8

Go to Step 7

Replace the wiper motor cover. Refer to Wiper Motor Cover Replacement .

Is the replacement complete?

--

Go to Wiper/Washer System Check

--

Repair the short to voltage in CKT 113.

Is the repair complete?

--

Go to Wiper/Washer System Check

--