Removal Procedure
- Remove the overhead console.
- Remove the driver information
display to overhead console screws.
- Remove the driver information display from the overhead console.
Installation Procedure
- Install the driver information
display to overhead console.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the driver
information display to overhead console screws.
Tighten
Tighten the screws to 1 N·m (9 lb in).
- Install the overhead console.
- Set the compass variance. Refer to
Driver Information Center (DIC) or Message Center Operation
.
Calibrate the compass.