Removal Procedure
- Remove the instrument panel knee bolster. Refer to
Knee Bolster Replacement
in Instrument Panel, Gauges and Console.
- Remove the ignition lock cylinder. Refer to
Ignition Lock Cylinder Replacement - On Vehicle
in Steering Wheel and Column-Tilt.
- Remove the upper steering column shroud.
- Disconnect the electrical connector at the base of the steering
column
- Pull the PASS-Key III® module from
the ignition lock cylinder housing.
- Remove the electrical connector and wires from the steering column.
- Remove the PASS-Key III® module from the vehicle.
Installation Procedure
- Install the PASS-Key III® module to the vehicle.
- Install the electrical connector and wires to the column.
- Slide the PASS-Key III® module over
the ignition lock cylinder housing.
- Connect the electrical connector at the base to the steering column.
- Install the upper column shroud.
- Install the ignition lock cylinder. Refer to
Ignition Lock Cylinder Replacement - On Vehicle
in Steering Wheel and Column-Tilt.
- Install the instrument panel knee bolster. Refer to
Knee Bolster Replacement
in Instrument Panel, Gauges and Console.