Automatic Door Lock Operation Modes
| • | Shift out of PARK lock enabled (modes 2, 3 and 4): Locks all doors when shifting the transaxle out of PARK with the driver's door closed. |
| • | Ignition OFF unlock enabled (mode 3): Unlocks all doors when turning the ignition switch from the RUN to the UNLOCK position. |
| • | Shift into PARK unlock enabled (mode 4): Unlocks all doors when shifting the transaxle into PARK. |
Changing the Automatic Door Lock Operation Mode
Perform the following procedure to change the automatic door lock operation mode:
- Turn off the IP dimmer switch.
- Turn the ignition switch to the LOCK position.
- Remove the BCM PRGRM fuse.
- Turn the ignition switch to the ACC position.
- To change the automatic door lock operation mode, press and release the LOCK on either door lock switch.
| • | The BCM sounds the chime a number of times equivalent to the BCM type installed on the vehicle (1, 2, 3, or 4 chimes). |
| • | Now the BCM has entered the feature customization mode. |
| • | The BCM sounds the chime a number of times equivalent to the automatic door lock operation mode. |
| • | A transition past mode 4 repeats the sequence starting with mode 1. |
The automatic door lock operation modes are as follows:
MODE | Shift Out Of Park Lock | Ignition Off Unlock | Shift Into Park Unlock |
|---|---|---|---|
1 | Disabled | Disabled | Disabled |
2 | Enabled | Disabled | Disabled |
3 | Enabled | Enabled | Disabled |
4 | Enabled | Disabled | Enabled |
To exit and save the current customization mode:
- Turn the ignition switch to the lock position.
- Reinstall the BCM PRGRM fuse.
If unable to change lock modes, refer to Feature Customization Mode Inoperative for diagnosis and repair.
Locking Control Modes
| • | Last door closed locking enabled (modes 3 and 4): When pressing LOCK on either door lock switch with the ignition switch in the LOCK position, this mode locks all doors five seconds after closing all vehicle doors. |
| • | Lockout prevention enabled (modes 2 and 4): When pressing LOCK on either door lock switch with the key in the ignition cylinder and the driver's door is open, the BCM does not lock the doors. |
Changing the Locking Control Mode
Perform the following procedure to change the locking control mode:
- Turn off the IP dimmer switch.
- Turn the ignition switch to the LOCK position.
- Remove the BCM PRGRM fuse.
- Turn the ignition switch to the ACC position.
- To change the locking control mode; press and release the UNLOCK on either door lock switch.
| • | The BCM sounds the chime a number of times equivalent to the BCM type installed on the vehicle (1, 2, 3, or 4 chimes). |
| • | Now the BCM has entered the feature customization mode. |
| • | The BCM sounds the chime a number of times equivalent to the locking control mode. |
| • | A transition past mode 4 repeats the sequence starting with mode 1. |
The locking control modes are as follows:
Mode | Last Door Closed Locking | Lockout Prevention |
|---|---|---|
1 | Disabled | Disabled |
2 | Disabled | Enabled |
3 | Enabled | Disabled |
4 | Enabled | Enabled |
To exit and save the current customization mode:
- Turn the ignition switch to the LOCK position.
- Reinstall the BCM PRGRM fuse.
If unable to change locking modes, refer to Feature Customization Mode Inoperative for diagnosis and repair.
