NEW INPUT CLUTCH AND 3RD CLUTCH SEAL INSTALLERS
1985-88 6000, BONNEVILLE AND GRAND PRIX EQUIPPED WITH THM 440-T4 (ME9)
New seal installation tools for the input clutch inner piston seal (629) and the 3rd clutch inner piston seal (635). These tools are to be used when servicing the input clutch assembly on all 1985-1988 vehicles equipped with a THM 440-T4 transaxle.
DATE OF PRODUCTION CHANGE: (Figure 1) --------------------------
July 29, 1986 (Julian Date 210) all 1987 THM 440-T4 transaxles were built using a new design input housing and shaft assembly (626). Refer to Figure 2 for the specific changes.
When servicing the input clutch housing and shaft assembly on a 1985-1988 THM 440-T4 transaxle use the new seal installation tools, J 37361 and J 37362 (Figure 3). The previous design tools, J 34091 and J 34092 will work on 1985-1986 transaxles only.
Use Figure 3 to update information contained in your 1987 and 1988 THM 440-T4 Automatic Transaxle Unit Repair section.
For warranty purposes, when replacing the input clutch inner piston seal and 3rd clutch inner piston seal use Labor Operation K7535. For this operation, and to recondition the transaxle completely, refer to the appropriate Labor Time Guide for applicable labor time information.
General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.