Schematic Reference: Instrument Cluster Schematics

Did you perform the IPC Diagnostic System Check?

Go to Step 2

Go to Diagnostic System Check - Instrument Cluster

1. Turn OFF the ignition.
2. Disconnect the ambient air temperature sensor.
3. Connect a 3A fused jumper wire between the signal circuit and the ground circuit of the ambient air temperature sensor.
4. Turn ON the ignition, with the engine OFF.

Does the DIC display SC?

Go to Step 5

Go to Step 3

Test the signal circuit of the ambient air temperature sensor for a short to voltage, a high resistance, or an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 9

Go to Step 4

Test the ground circuit of the ambient air temperature sensor for a high resistance, a short to voltage, or an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 9

Go to Step 6

Inspect for poor connections at the harness connector of the ambient air temperature sensor. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 9

Go to Step 7

Inspect for poor connections at the harness connector of the IPC. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 9

Go to Step 8

Replace the ambient air temperature sensor. Refer to Ambient Temperature Sensor Replacement .

Did you complete the replacement?

Go to Step 9

--

Important: Perform the compass calibration and variance procedure on the replacement IPC.

Replace the IPC. Refer to Instrument Cluster Replacement .

Did you complete the replacement?

Go to Step 9

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 2