Security Indicator LED Inoperative. Pontiac Aztek

For 1990-2009 cars only

Makes 🢒 Pontiac 🢒 2005 🢒 Aztek - AWD 🢒 Vehicle Control Systems 🢒 Vehicle DTC Information 🢒 Security Indicator LED Inoperative

Step	Action	Yes	No
Schematic Reference: Theft Deterrent System Schematics Connector End View Reference: Theft Deterrent System Connector End Views
1	Did you perform the Diagnostic System Check - Vehicle?	Go to Step 2	Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2	Arm the content theft system. Refer to Content Theft Deterrent (CTD) Description and Operation . Does the security indicator LED illuminate?	Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems	Go to Step 3
3	Turn OFF the ignition. Disconnect the body control module (BCM) connector containing the LED control circuit. Ground the security indicator LED circuit with a fused jumper wire and appropriate terminal adapter. Does the security indicator LED illuminate?	Go to Step 6	Go to Step 4
4	Disconnect the security indicator LED. Probe the security indicator LED battery positive voltage circuit with a test lamp connected to ground. Does the test lamp light?	Go to Step 5	Go to Step 8
5	Test the security indicator LED control circuit for an open or short to battery. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 11	Go to Step 7
6	Inspect for poor connections at the harness connector of the BCM. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 11	Go to Step 9
7	Inspect for poor connections at the harness connector of the security indicator LED. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 11	Go to Step 10
8	Repair the open or short to ground in the security indicator LED battery positive voltage circuit. Refer to Wiring Repairs in Wiring Systems. Did you complete the repair?	Go to Step 11	--
9	Replace the BCM. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement?	Go to Step 11	--
10	Replace the security indicator LED. Refer to LED Indicator Replacement - Vehicle Security System . Did you complete the replacement?	Go to Step 11	--
11	Operate the system in order to verify the repair. Did you correct the condition?	System OK	Go to Step 3