The body control module (BCM) controls the automatic transmission (A/T) shift lock control solenoid ground circuit and monitors the voltage of the ground control circuit.
This diagnostic procedure supports the following DTC:
DTC B2713 Gearshift Lock Circuit High
The controlled ground circuit of the A/T shift lock control solenoid must be ON.
• | The BCM detects the controlled ground circuit voltage is approximately equal to battery voltage in the ON state. |
• | The condition above must be present for more than 0.3 seconds. |
• | This DTC will be set after 20 seconds due to possible false failures. |
The BCM stores DTC B2713 in memory.
• | The BCM determines that the controlled ground circuit of the A/T shift lock control solenoid is no longer shorted to battery voltage. |
• | A history DTC B2713 will clear after 100 consecutive ignition cycles if the condition for the malfunction is no longer present. |
• | A scan tool may be used to clear the DTC. |
• | If DTC B2713 is a history DTC, the fault may be intermittent. Refer to Testing for Intermittent Conditions and Poor Connections in Wiring Systems. |
• | The following conditions may cause an intermittent malfunction to occur: |
- | An intermittent short to battery voltage in the controlled ground circuit of the A/T shift lock control solenoid |
- | The A/T shift lock control solenoid coil is shorted to battery voltage internally. |
- | The BCM is shorted to battery internally. |
Step | Action | Yes | No |
---|---|---|---|
Schematic Reference: Shift Lock Control Schematics Connector End View Reference: Shift Lock Control Connector End Views or Computer/Integrating Systems Connector End Views in Computer/Integrating Systems | |||
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
2 |
Does the automatic transmission (A/T) shift lock control system operate correctly? | Go to Diagnostic Aids |