GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2004 🢒 Aztek - FWD 🢒 Bulletins 🢒 SMU - Revised Bracket Replacement - Console Floor Procedure

SMU - Revised Bracket Replacement - Console Floor Procedure

Subject:Revised Bracket Replacement - Console Floor Procedure

Models:2002-2005 Buick Rendezvous
2001-2005 Pontiac Aztek


This bulletin is being issued to revise the Bracket Replacement-Console Floor procedure in the Instrument Panel, Gages and Console sub-section of the Service Manual. Please replace the current information in the Service Manual with the following information.

The following information has been updated within SI. If you are using a paper version of this Service Manual, please make a reference to this bulletin on the affected page.

Bracket Replacement - Console Floor

Removal Procedure

  1. Remove the front floor console. Refer to Console Replacement -- Front Floor.
  2. Disconnect the console electrical center from the floor-console bracket and move aside, out of the way.
  3. Remove the floor shift control. Refer to Floor Shift Control Replacement in Automatic Transaxle - 4T65-E.

    4. Object Number: 618054 Size: SH
  4. Remove the upper bolts (2) from the instrument panel (I/P).
  5. Remove the lower nuts (1) from the floor.
  6. Remove the front floor console bracket from the floor.

Installation Procedure


    Object Number: 618054 Size: SH
  1. Align the front floor console bracket to the floor.

    2. Notice: Refer to Fastener Notice.

  2. Install the lower nuts (1) to the front floor console bracket.

    3. Tighten
    Tighten the nuts to 10 N·m (89 lb in).

  3. Install the upper bolts/screws (2) to the I/P.

    4. Tighten
    Tighten the bolts/screws to 2.5 N·m (22 lb in).

  4. Install the floor shift control. Refer to Floor Shift Control Replacement in Automatic Transaxle - 4T65-E.
  5. Install the console electrical center to the original location.
  6. Install the front floor console. Refer to Console Replacement - Front Floor.