For 1990-2009 cars only
Removal Procedure
- Disable the SIR. Refer to SIR Disabling and Enabling.
- Adjust the front seat assembly up and forward in order to access the fasteners (1) at the rear of the front seat cushion assembly.
- Remove the fasteners.
- Adjust the front seat assembly to the rear of the vehicle.
- Angle the front seat cushion (1) up, in order to access the assembly fasteners (2).
- Remove the fasteners.
- Lift the front seat cushion assembly (1) away from the seat riser.
- Disconnect the electrical connector.
- Using a flat-bladed tool, release the module from the bracket.
- Remove the memory seat module from the seat frame.
Caution: Refer to SIR Caution in the Preface section.
Installation Procedure
- Install the memory seat module to the seat frame.
- Press the module into the bracket until the module is firmly seated.
- Connect the electrical connector to the memory seat module.
- Install the seat cushion assembly (1) to the seat riser.
- Install the fasteners (2) to the seat cushion assembly (1).
- Adjust the front seat assembly up and forward in order to access the fasteners (1).
- Install the fasteners (1) to the seat cushion assembly.
- Angle the front seat cushion up, in order to access the assembly fasteners.
- Enable the SIR. Refer to SIR Disabling and Enabling.
- Calibrate the seat. Refer to Control Module References for programming and setup information.
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the fasteners to 9 N·m (80 lb in).
Tighten
Tighten the fasteners to 9 N·m (80 lb in).
