Step | Action | Yes | No |
|---|---|---|---|
Schematic Reference: Exterior Lights Schematics Connector End View Reference: Master Electrical Component List | |||
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | |
2 | Place the hazard switch to OFF. Are the hazard lamps OFF? | Go to Testing for Intermittent Conditions and Poor Connections | Go to Step 3 |
3 | Remove the hazard flasher. Do the hazard lamps turn OFF? | Go to Step 4 | Go to Step 6 |
4 | Inspect for a short to ground in the hazard switch signal circuit. Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition? | Go to Step 9 | Go to Step 5 |
5 |
Does the test lamp illuminate? | Go to Step 7 | Go to Step 8 |
6 | Inspect for poor connection at the harness connectors of the underhood fuse block. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs . Did you find and correct the condition? | Go to Step 12 | Go to Step 9 |
7 | Inspect for poor connections at the harness connector of the multifunction turn signal and hazard switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs . Did you find and correct the condition? | Go to Step 12 | Go to Step 10 |
8 | Inspect for poor connections at the harness connector of the hazard flasher. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs . Did you find and correct the condition? | Go to Step 12 | Go to Step 11 |
9 | Replace the console fuse block. Refer to Underhood Electrical Center or Junction Block Replacement . Did you complete the replacement? | Go to Step 12 | -- |
10 | Replace the multifunction turn signal and hazard switch. Refer to Turn Signal Multifunction Switch Replacement . Did you complete the replacement? | Go to Step 12 | -- |
11 | Replace the hazard flasher. Did you complete the replacement? | Go to Step 12 | -- |
12 | Operate the system in order to verify the repair. Did you correct the condition? | System OK | Go to Step 3 |
