For 1990-2009 cars only
Removal Procedure
- Remove the overhead console door (1).
- Reach your hand through the access opening and disconnect the microphone connector (2) from the jumper harness.
- Unsnap the microphone bracket from the overhead console.
- Disconnect the microphone 2-way connector from the mating 2-way connector.
Installation Procedure
- Reach your hand through the access opening and install the microphone to the overhead console at the left rear corner of the overhead console.
- Snap the microphone bracket to the overhead console.
- Connect the microphone connector (2) to the mating 2-way connector.
- Install the overhead console door (1).
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Install the screws securing the overhead console door.
Tighten
Tighten the screws to 10 N·m (89 lb in).
