CAMPAIGN: WINDSHIELD WASHER BOTTLE BRACKET
MODELS AFFECTED: 1987 Bonnevilles
The National Traffic and Motor Vehicle Safety Act, as amended, provides that each vehicle which is subject to a recall campaign of this type, must be adequately repaired within a reasonable time after the owner has tendered it for repair. A failure to adequately repair within sixty days after tender of a vehicle is prima facie evidence of failure to repair within a reasonable time.
If the condition is not adequately repaired within a reasonable time the owner may be entitled to an identical or reasonable equivalent vehicle at no charge or to a refund of the purchase price, less a reasonable allowance for depreciation.
To avoid having to provide these burdensome solutions, every effort must be made to promptly schedule an appointment with each owner and to repair their vehicle as soon as possible. As you will see in reading the attached copy of the letter which is being sent to owners, the owners are being instructed to contact the Pontiac Customer Assistance Center if their dealer does not remedy the condition within five days of the mutually agreed upon service date. If the condition is not remedied within a reasonable time, owners are instructed on how to contact the National Highway Traffic Safety Administration.
CONDITION INVOLVED
General Motors has determined that a defect which relates to motor vehicle safety exists in some 1987 Pontiac Bonneville models. These vehicles have in-line fusible links located in the area of the plastic windshield washer bottle bracket. Under a high resistance load, the in-line fusible link may melt down and ignite the windshield washer bottle bracket resulting in an engine compartment fire, without prior warning.
To prevent this condition, dealers are required to replace windshield washer bottle bracket on suspect vehicles, as described in the Service Procedure sections of this bulletin.
VEHICLES INVOLVED
1987 Bonneville models assembled within the following VIN breakpoints:
Model Through Year Plant Beginning & Including ---- ----- --------- ----------- 1987 Willow Run HWO00001 HW 301148
Involved vehicles have been identified by Vehicle Identification Number computer listings. Computer listings contain the complete Vehicle Identification Number, owner name and address data, and are furnished to the involved dealers with the campaign bulletin. Owner name and address data furnished will enable dealers to follow up with owners involved in this campaign.
These listings may contain owner names and addresses obtained from State Motor Vehicle Registration Records. The use of such motor vehicle registration data for any other purpose is a violation of law in several states. Accordingly, you are urged to limit the use of this listing to the follow up necessary to complete this campaign. Any dealer not receiving a computer listing with the campaign bulletin has no involved vehicles currently assigned.
OWNER NOTIFICATION
Owners will be notified of this campaign on their vehicles by Pontiac Division (see copy of Owner Letter included with this bulletin).
DEALER CAMPAIGN RESPONSIBILITY
Dealers are to service all vehicles subject to this campaign at no charge to owners, regardless of mileage, age of vehicle, or ownership from this time forward.
Whenever a vehicle subject to this campaign is taken into your new or used vehicle inventory, or it is in your dealership for service in the future, you should take the steps necessarv to be sure the campaign correction has been made before reselling or releasing the vehicle.
Owners of vehicles recently sold from your new vehicle inventory are to be contacted by the dealer, and arrangements made to make the required modification according to instructions contained in this bulletin.
PARTS INFORMATION
Parts are to be obtained from General Motors Service Parts Organization (GMSPO) using the following part number:
Description Part Number ----------- ----------- Windshield Washer Bottle Bracket 25533178
To ensure that this part will be obtained as soon as possible, it should be ordered from GMSPO on a C.I.O. order with no special instruction code, but order on an advise code (2).
SERVICE PROCEDURE
1. Open vehicle hood, cover right front fender, and disconnect negative battery cable at battery.
2. Remove engine compartment right front sight shield. Disconnect positive and negative junction block leads at right wheelhouse on windshield washer bottle bracket studs.
3. Remove two screws securing washer fluid bottle to bracket. Set washer fluid bottle off of bracket leaving washer pump and fluid line attached.
4. Remove two screws holding windshield washer bottle bracket to right wheelhouse.
5. Install new windshield washer bottle bracket, Part Number 25533178. Torque bracket retaining screws to 5-7N m (4-5 lb. ft.).
6. Reverse steps 1 to 3 to reassemble. Torque junction block negative nut to 6-9 N m (5-7 lb. ft.), and positive nut to 14-20 N m (10-15 lb. ft.).
7. Install campaign identification label.
CAMPAIGN IDENTIFICATION LABEL (Figure 1)
Each vehicle modified in accordance with the instructions outlined in this Product Campaign Bulletin will require a "Campaign Identification Label." Each label provides a space to include the campaign number, the five digit dealer code of the dealer performing the campaign service, and the date the vehicle was campaigned. This information may be inserted with a typewriter or ball point pen. Install the label only on a clean, dry surface of the radiator baffle where it is readily visible. (Additional campaign labels are available on stationery order as Form 7901-709).
CLAIM INFORMATION
A separate repair order must be used for each vehicle. A completed warranty claim is to be kept as a permanent record of completion.
DEALERS SHOULD SUBMIT WARRANTY CLAIMS FOR CREDIT IN THEIR NORMAL MANNER WHEN THEY PERFORM THE SERVICE AS FOLLOWS:
Other* Failure Labor Labor Labor Operation Code Operation Hours Hours --------- ---- --------- ----- ----- Replace Windshield Washer Bottle Bracket 96 V4210 .3 .1
*In addition dealerships will receive 0.1 hours credit for dealer administrative services associated with this campaign. The 0.1 hours allowance is to be entered in the "Other Labor Hours" field with each campaign repair listed for credit. This entry will not require authorization.
FAILURE CODE 96 MUST BE USED WITH THE LABOR OPERATION.
Parts required are to be listed in your warranty claim in the normal manner. Parts will be credited at dealer net plus 30% dealer handling allowance.
Dealers will be credited via Warranty Document or Terminal Transmission, whichever is their normal method of submission for payment. Claim must contain all information required and should list the labor operation as outlined.
RECORDING COMPLETION
Repairs submitted for vehicles not involved in the campaign will not be paid.
Campaign completion will be recorded from "PROPERLY COMPLETED AND PAID WARRANTY CLAIMS." Owners are being asked to present the owner reply card for identification to their dealer at the time they bring in their vehicle to have the campaign performed.
General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.
