FIRM OR HARD FRT. SEAT PROCEDURE TO SOFTEN SEAT

EARLY 1987 BONNEVILLE MODELS (INTO JANUARY PRODUCTION)

If a comment on firm or hard front seat cushion is received, the following procedure can be used to soften either driver or passenger side:

- See Illustrations.

- Determine if correction has already been done, reach under seat to check if center element (spring) is present. If so, continue to next step.

- Remove front seat.

- Detrim seat bottom, front, and sides. It is not necessary to remove adjusters.

- Remove two (2) hog rings from rear of seat trim, to gain access to rear of element.

- Remove front and rear clips from center element.

- Open attaching tabs on seat frame, at ends of element.

- Remove element only from side which condition exists.

- Retrim seat.

- Reinstall seat.

WARRANTY INFORMATION

Labor Operation Numbers: Labor Time:

T5135 Split Seat .7 for each side T5136 Bench Seat .7 for one (1) side T5137 Bench Seat .8 for both sides

Trouble Code: 92

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.