CUP HOLDER SEPARATING AT CUP (REPLACE CUP HOLDER)

SUBJECT: CUP HOLDER SEPARATING AT CUP (REPLACE CUP HOLDER)

MODELS: 1992-95 PONTIAC BONNEVILLE WITH CENTER CONSOLE

CONDITION:

SOME OWNERS MAY COMMENT ON THE CUP HOLDER SEPARATING AT THE CUP.

CORRECTION:

A NEW DESIGN HAS BEEN DEVELOPED TO ALLOW CUP HOLDER TO BE SERVICED SEPARATELY FROM CONSOLE BIN COMPARTMENT TRIM PANEL.

1. OPEN CONSOLE BIN DOOR TO ACCESS CUP HOLDER ARMS.

NOTICE: CARE SHOULD BE TAKEN TO ENSURE THAT THE HINGE PINS AND SURROUNDING TRIM ARE NOT DAMAGED DURING MATERIAL OR ARM REMOVAL.

2. CAREFULLY REMOVE CUP HOLDER ARM MATERIAL AT HINGE PINS (WITH SMALL DIAGONAL SIDE CUTTERS) TO ALLOW REMOVAL OF CUP HOLDER ARMS. REFER TO FIGURES 1 AND 2.

3. WITH THE CUP HOLDER, P/N 25639346, FACE DOWN TOWARD THE CONSOLE BIN, INSERT ARMS UNDER HINGE PINS.

4. ALIGN CUP HOLDER SLOTS WITH HINGE PINS AND CAREFULLY PULL TO SEAT ARMS OVER PINS. VERIFY PROPER OPERATION.

PARTS INFORMATION:

PARTS ARE EXPECTED TO AVAILABLE ON SEPTEMBER 4, 1995.

WARRANTY INFORMATION:

FOR VEHICLES REPAIRED UNDER WARRANTY, USE:

LABOR OPERATION NUMBER: C2745 USE PUBLISHED LABOR OPERATION TIME.

FIGURES: 2

GENERAL MOTORS BULLETINS ARE INTENDED FOR USE BY PROFESSIONAL TECHNICIANS, NOT A "DO-IT-YOURSELFER". THEY ARE WRITTEN TO INFORM THOSE TECHNICIANS OF CONDITIONS THAT MAY OCCUR ON SOME VEHICLES, OR TO PROVIDE INFORMATION THAT COULD ASSIST IN THE PROPER SERVICE OF A VEHICLE. PROPERLY TRAINED TECHNICIANS HAVE THE EQUIPMENT, TOOLS, SAFETY INSTRUCTIONS AND KNOW-HOW TO DO A JOB PROPERLY AND SAFELY. IF A CONDITION IS DESCRIBED, DO NOT ASSUME THAT THE BULLETIN APPLIES TO YOUR VEHICLE, OR THAT YOUR VEHICLE WILL HAVE THAT CONDITION. SEE A GENERAL MOTORS DEALER SERVICING YOUR BRAND OF GENERAL MOTORS VEHICLE FOR INFORMATION ON WHETHER YOUR VEHICLE MAY BENEFIT FROM THE INFORMATION.

COPYRIGHT 1995 GENERAL MOTORS CORPORATION. ALL RIGHTS RESERVED.