REVISION: 03/03/97
THIS BULLETIN IS BEING REVISED TO UPDATE THE APPLICABLE MODELS AND YEARS. PLEASE DISCARD CORPORATE BULLETIN NUMBER 63-10-41 (SECTION 10 - BODY). ---------------------------------------------------------------------- REVISION: 11/17/97
THIS BULLETIN IS BEING REVISED TO ADD THE 1992-97 BUICK/OLDSMOBILE N CAR. PLEASE DISCARD CORPORATE BULLETIN NUMBER 63-10-41A (SECTION 10 - BODY). ----------------------------------------------------------------------
1996-97 CHEVROLET AND GMC G MODELS 1996-97 CHEVROLET AND GMC S/T MODELS 1996-97 OLDSMOBILE BRAVADA
SOME OWNERS MAY COMMENT ON INOPERATIVE POWER DOOR LOCKS (FRONT AND/OR REAR DOORS). DOOR LOCKS WILL STILL OPERATE MANUALLY.
CONDITION MAY BE CAUSED BY RIPPING OF THE EXTERNAL BUMPER WHICH ALLOWS THE ACTUATOR ARM TO DISENGAGE.
REPLACE EXTERNAL BUMPER ON ACTUATOR ARM.
NUMBERS IN PARENTHESIS BELOW REFER TO CALLOUTS IN ILLUSTRATION.
1. REMOVE THE DOOR LATCH ASSEMBLY. REFER TO SECTION 10 IN THE SERVICE MANUAL.
2. SEPARATE THE ACTUATOR FROM THE LATCH ASSEMBLY BY REMOVING TWO SCREWS (5).
3. REPLACE EXTERNAL BUMPER (3) ON ACTUATOR ARM (2) WITH NEW BUMPER SUPPLIED IN SERVICE KIT.
- THE OLD STYLE BUMPER IS NEUTRAL OR WHITE IN COLOR AND SHOULD BE REPLACED WITH A NEW BLACK BUMPER.
- DO NOT ADD ANY LUBRICANT TO THE BUMPER OR BUMPER AREA.
4. INSTALL THE ACTUATOR TO THE LATCH ASSEMBLY.
- ENSURE THAT THE LOCK SWITCH TEETH (11) ARE PUSHED ALL THE WAY TOWARDS THE ACTUATOR ARM AND THE LATCH IS IN THE FULL OPEN POSITION.
5. REPLACE LOCK ROD CLIPS SUPPLIED IN KIT.
6. REINSTALL LOCK ACTUATOR.
7. INSURE PROPER OPERATION OF LOCKS.
ACTUATOR KIT BUMPER REPAIR P/N 25664043
PARTS ARE CURRENTLY AVAILABLE FROM GMSPO.
FOR VEHICLES REPAIRED UNDER WARRANTY, USE:
LABOR OPERATION DESCRIPTION LABOR TIME ========== =========== ==========
N3214-15 ACTUATOR ASM. - USE PUBLISHED TIMES REPLACE FRT DOOR
N3224-25 ACTUATOR ASM. - REPLACE RR. DOOR
FIGURES: 01 ATTACHMENTS: 00
FIGURE 1: 1. DOORLOCK/SWITCH ASSEMBLY 2. ACTUATING ARM 3. RUBBER BUMPER 4. LATCH ASSEMBLY 5. SCREW 6. OUTSIDE HANDLE LEVER 7. KEY CYLINDER ROD LEVER 8. LOCKING LEVER 9. FORK BOLT 10. FORK BOLT TEETH 11. SWITCH TEETH 12. ELECTRICAL CONNECTOR 13. ROD ATTACHMENT CLIP
GENERAL MOTORS BULLETINS ARE INTENDED FOR USE BY PROFESSIONAL TECHNICIANS, NOT A "DO-IT-YOURSELFER". THEY ARE WRITTEN TO INFORM THOSE TECHNICIANS OF CONDITIONS THAT MAY OCCUR ON SOME VEHICLES, OR TO PROVIDE INFORMATION THAT COULD ASSIST IN THE PROPER SERVICE OF A VEHICLE. PROPERLY TRAINED TECHNICIANS HAVE THE EQUIPMENT, TOOLS, SAFETY INSTRUCTIONS AND KNOW-HOW TO DO A JOB PROPERLY AND SAFELY. IF A CONDITION IS DESCRIBED, DO NOT ASSUME THAT THE BULLETIN APPLIES TO YOUR VEHICLE, OR THAT YOUR VEHICLE WILL HAVE THAT CONDITION. SEE A GENERAL MOTORS DEALER SERVICING YOUR BRAND OF GENERAL MOTORS VEHICLE FOR INFORMATION ON WHETHER YOUR VEHICLE MAY BENEFIT FROM THE INFORMATION.
COPYRIGHT 1997 GENERAL MOTORS CORPORATION. ALL RIGHTS RESERVED.