Important: Excessive moisture in the vehicle could affect system performance, this could be caused by:

Important: The A/C compressor will not operate (to reduce humidity) in ambient temperatures below 5°C (41°F).

Did you perform the HVAC Diagnostic System Check?

--

Go to Step 2

Go to Diagnostic System Check

1. Turn ON the ignition, with the engine OFF.
2. Select DEFROST mode.
3. Ensure that the defrost outlet on top of the instrument panel is unobstructed.
4. Adjust blower speed from minimum to maximum.
5. With a scan tool, observe the Commanded Blower data parameter in the Climate Control Panel data list.

Does the scan tool indicate that the Commanded Blower data parameter is greater than the specified value?

100%

Go to Step 3

Go to Blower Motor Does Not Operate Properly

1. Set blower speed to maximum.
2. Select DEFROST, DEFOG and PANEL modes.

Does the airflow change discharge locations?

--

Go to Step 4

Go to Air Delivery Improper

Important:: Outside air temperature must be above 7°C (45°F)

1. Start the engine.
2. Adjust driver side temperature to maximum.
3. Select DEFROST mode.
4. Set blower speed to maximum.
5. Let the engine idle at normal operating temperature.

Does the A/C Compressor operate?

--

Go to Step 5

Go to HVAC Compressor Clutch Does Not Engage

With a scan tool, observe the ECT data parameter in the powertrain control module data list.

Does the scan tool indicate that the ECT data parameter is within the specified range?

87°C to 98°C (188°F to 208°F)

Go to Step 6

Go to Symptoms in Engine Cooling

Is the defrost airflow warm?

--

Go to Step 7

Go to Heating Insufficient

Is the defrost airflow sufficient and is the left defrost airflow similar to the right defrost airflow at the defroster grille and side window outlets?

--

Go to Step 10

Go to Step 8

1. Turn OFF the engine.
2. Inspect for obstructions and proper defrost duct alignment. Refer to Defroster Grille Replacement or Defroster Grille Replacement in Instrument Panel, Gauges and Console.

Did you find and correct the condition?

--

Go to Step 11

Go to Step 9

Inspect the mode door actuator for binding or mechanical failure. Refer to Mode Actuator Replacement .

Did you find and correct the condition?

--

Go to Step 11

Go to Step 10

1. Start the engine.
2. Verify all the instrument panel outlets are open.
3. Operate the system. Refer to the appropriate procedure:

•	Air Conditioning (A/C) System Description

•	Control Assembly Description

•	Operating Modes

Does the system operate properly?

--

System OK

Go to Symptoms

Operate the system in order to verify the repair.

Did you correct the condition?

--

System OK

Go to Step 2